Step 1:  I remove your return air duct cover as demonstrated. The equipment to carry out the work will be the flexi drive round brush, skipper ball with high air pressure to dislodge dust and powerful vacuum to extract debris. For very dusty return air ducts we use a flexi drive round brush.

Note: The flexi drive round brush is not used in all situations, it is only used if the return air duct is stern like the one shown below. For return air ducts that have softer materials, a high pressure air whip is used to dislodge the dust. For more info please contact Tony. Contact Us

Return air duct cover comes off.

Skipper ball is inserted into the return air duct.

Placing the flexi brush into the return air duct.

The flexi brush is pushed down the duct for cleaning

This image is a return air duct before it was cleaned.

This is the same return air duct after it was cleaned.

Cover panel is removed for the fan to be cleaned.

High air pressure is used to clean this dusty fan.

A clean fan is displayed using high air pressure.

Preparing to apply the duct cover over the register.

Equipment is at work cleaning your ducts, The combination of very high air pressure & powerful vacuum to dislodge and extract dust, debris.

Looking down into the duct register, is the skipper ball at work sweeping back dust & debris. Lager pieces of debris got into this duct because the flap was on a upright angle there for it was collecting rubbish over many years. This register was located in the kitchen.